| OZDAT https://ozdat.com.au/forum/ |
|
| Rear Brakes/Hand Brake https://ozdat.com.au/forum/viewtopic.php?t=7738 |
Page 1 of 1 |
| Author: | Razor [ Wed Apr 26, 2006 5:19 pm ] |
| Post subject: | Rear Brakes/Hand Brake |
Hi Just in the process of replacing the brake shoes on the rear on my N320 and replacing Axle seals as well. Now I want to remove the whole brake assembly but the hand brake cable is stock on the locking plate, now how do I remove the cable from the locking plate? or how do I remove the cable from the drums? I've attached some photos... ![[ img ]](http://img.photobucket.com/albums/v390/C110GTR/1200%20Ute/N320/RearHandcable1.jpg) ![[ img ]](http://img.photobucket.com/albums/v390/C110GTR/1200%20Ute/N320/RearHandcable2.jpg) ![[ img ]](http://img.photobucket.com/albums/v390/C110GTR/1200%20Ute/N320/RearHandcable3.jpg) And look how soaking wet the brake is from leaking oil ![[ img ]](http://img.photobucket.com/albums/v390/C110GTR/1200%20Ute/N320/RearBrake1.jpg)
|
|
| Author: | DANGER1600 [ Wed Apr 26, 2006 7:20 pm ] |
| Post subject: | LOCKING PLATE |
if you wanna just remove the cable from the plate see that clip just knock it out with either a hammer and screwdriver or chisel and then just feed the cable through it |
|
| Author: | Razor [ Wed Apr 26, 2006 8:30 pm ] |
| Post subject: | |
ok I thought its like spot welded on the bracket as I tried lightly hitting it with a flat screw driver and rubber hammer I'll try hitting it harder tomorrow thanks for the tip |
|
| Page 1 of 1 | All times are UTC+11:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|