OZDAT https://ozdat.com.au/forum/ |
|
CarbyQuery https://ozdat.com.au/forum/viewtopic.php?t=30903 |
Page 1 of 1 |
Author: | chunkylover43 [ Wed Mar 27, 2013 7:52 pm ] |
Post subject: | CarbyQuery |
I have heard of a trick to clear out an old carby by revving the engine and then blocking the intake with a handfull of rag. This supposedly sucks all the built up gunk out of the carb. Does this work and is there any potential for damage if I do it? Cheers |
Author: | Nissanman [ Wed Mar 27, 2013 8:45 pm ] |
Post subject: | Re: CarbyQuery |
Only if you lose the rag! I'm at this point myself. However, I have a carby rebuild kit so I'm going to strip it down and start again! |
Author: | chunkylover43 [ Wed Mar 27, 2013 9:19 pm ] |
Post subject: | Re: CarbyQuery |
I have a separate weber carb that I am planning on rebuilding soon but I might give this a go in the meantime. Thanks |
Author: | old-tin [ Wed Mar 27, 2013 10:10 pm ] |
Post subject: | Re: CarbyQuery |
It depends how bad the carb is. I do it all the time ( with the palm of my hand not a rag ) and works about 60% of the time. |
Author: | travm182 [ Wed Mar 27, 2013 10:26 pm ] |
Post subject: | Re: CarbyQuery |
Derek Hobbs from Datsport suggested I do this. Fixed my problem of terrible throttle response. |
Author: | nick [ Wed Mar 27, 2013 11:01 pm ] |
Post subject: | Re: CarbyQuery |
Itll either clear out the jets or block them even worse. Its worth a try, if it does get worse tho just take out all of the jets and clean them... |
Author: | chunkylover43 [ Sat Mar 30, 2013 9:15 pm ] |
Post subject: | Re: CarbyQuery |
I decided to put on a 32/36 DGAV instead. Progress: http://ozdat.com/forum/viewtopic.php?f= ... 00#p243400 |
Page 1 of 1 | All times are UTC+11:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |