| OZDAT http://ozdat.com.au/forum/ |
|
| Brisbane engineer suggestions http://ozdat.com.au/forum/viewtopic.php?t=34914 |
Page 1 of 1 |
| Author: | b_sydney [ Sat Nov 09, 2019 2:34 pm ] |
| Post subject: | Brisbane engineer suggestions |
Gday Im new to Ozdat. I recently purchased a 1970 datsun 1600 and am considering a full rebuild with an FJ20 conversion. I dont really know what is involved so am probably diving in over my head but as they say ""no pain no gain" A couple of things: Can anyone recommend an engineer in the brisbane region. I thought it best t start with them so I can look to build the car as to minimise road blocks for rego. Also, I know I will need to upgrade breaks. Are there any suspension and break setups from other cars that simply bolt straight into a 1600....such as 200b or 240z etc? Thanks heaps B |
|
| Author: | sutho510 [ Sun Nov 10, 2019 8:39 pm ] |
| Post subject: | Re: Brisbane engineer suggestions |
200b will bolt straight in but i dont think they’ll be big enough for a fj20 You would probably need atleast r31 size front brakes wich can be done by changing the spring perch. Have a look on the Datsport and maddat sites if you haven’t already |
|
| Author: | b_sydney [ Wed Nov 13, 2019 7:12 pm ] |
| Post subject: | Re: Brisbane engineer suggestions |
Thanks Sutho. This is exactly why I am looking for an engineer. Need to know what sizes I need before I spend too much $$ on the wrong gear. Thanks again |
|
| Page 1 of 1 | All times are UTC+11:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|