Get yours yet? Mine are waiting at the post office for me

Yep. A few days ago. Diff arrived this arvo. I rebuild the half shafts tonight. Will probably pull the did down and make sure every thing is good. Should be done by Friday.

_________________
1928 Model A CC Pickup

Nice one, Post lots of pics

First post has been edited as a quick tutorial.

_________________
1928 Model A CC Pickup

What use will that be? Real 200Bs have live axle, none of this IRS rubbish

Good work with the write-up, I can't see it ever being much use to me but for many others it will be a valuable set of instructions for a great conversion.

_________________
green200b - aka Alistair

The fleet:

Australia:
'80 200B GX - the green200b - hibernating
'81 RX-7 - 12A extend port - daily
'74 RX-2 - 13B bridgeport - cruiser

Europe:
'93 200SX - CA18DET - tourer

nice work Brad. I'll be dropping mine off to diff shop next week to get new bearings and kaaz fitted, then skids (after 30min of figure 8s).
Do you know if/when beta motorsports will be doing another run? I was under the impression that there have only ever been 32 sets made and all are sold...

Exactly Al

_________________
1928 Model A CC Pickup

will a sti clutch pack center fit onto a datsun crown wheel? modifications required?
Eg can you use a 5.1 datsun diff and install a sti center with these adapters

_________________
Circuit Race 1600 in the build

Not 100% sure. I was going to give it a go with a late model R180 from a S12 (diff with the big K stamped on it). I ran out of time and just wanted to get the thing installed. Click on the link in the first page for the forum thread and ask. John C should know for sure.

_________________
1928 Model A CC Pickup

Chhers mate. Thanks for sending the output flange as well. It's my understanding John waits for people to contact him with the intent of buying a set. He bangs them on a list and then when there is 20 or so he orders them.

_________________
1928 Model A CC Pickup

im down for a pair if anyone else contacts him

_________________
]

Tick

_________________
1928 Model A CC Pickup

i think im going to buy a set

_________________
Circuit Race 1600 in the build

I think someone on hybridz put a subaru lsd into a datsun and found he had to grind the housing to make it fit. I will try lining crownwheel bots up today.

If anyone wants a pair now rather than in 6months time when another batch gets made, PM me.

Tried fitting a datsun crownwheel over my kaaz subaru LSD and it did not fit. Would need to machine 3-5mm out of the inside of the crownwheel to make it work. Not sure if a standard STI LSD would be the same but I expect so. As such I am now needing a subaru 3.9 R180!