OZDAT http://ozdat.com.au/forum/ |
|
Replacing Side Oil Seals - R180 http://ozdat.com.au/forum/viewtopic.php?t=34461 |
Page 1 of 1 |
Author: | Anth510 [ Mon Feb 13, 2017 2:08 pm ] |
Post subject: | Replacing Side Oil Seals - R180 |
hi guys, Getting a slow weep from my passenger-side output shaft area on my diff (R180), can only assume it's the side seal. Just trying to do some reading up on whether it's something I can do on the ground with the diff in the car, or if I should just take it somewhere and avoid cursing life while I'm lying under the car. Has anyone changed these before, any hints/tips? These are some links I've found... http://woodworkerb.com/home/datsun-240z ... ferential/ (scroll down past half-way, until you reach the heading "Replacing the side seals" http://www.classiczcars.com/topic/46166 ... placement/ Note that these are both done out of the car, with the diff on a bench. I have changed my transmission output shaft seal a few times, so I'm guessing it'll be a similar deal? As far as parts go, I can't find any genuine Nissan seals, only the "Beck/Arnley 052-1401". Ebay link. cheers! |
Author: | Lurch [ Mon Feb 13, 2017 10:32 pm ] |
Post subject: | Re: Replacing Side Oil Seals - R180 |
Nissan R180 side lip seal Part No: 38342-21000 |
Author: | Anth510 [ Tue Feb 14, 2017 12:17 pm ] |
Post subject: | Re: Replacing Side Oil Seals - R180 |
Thank you, good sir! |
Author: | Imago [ Fri Feb 17, 2017 8:25 am ] |
Post subject: | Re: Replacing Side Oil Seals - R180 |
I changed them on my R180 and R200. Just like a regular crank/cam seal though with the shafts out you can lever them quite easily with a screwdriver or ideally a seal remover tool. Installation is normal too - either hammer with an even block matching diameter pipe or slowly with a punch. I can't remember if the seals I used had the flare on them last time. Usually if you don't buy the Nissan ones a regular seal shop will have the right one without the extra flare to reduce dust. If it's strictly a tar car I think you could get away with it. |
Page 1 of 1 | All times are UTC+11:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |