OZDAT http://ozdat.com.au/forum/ |
|
Casting a new big bore L16 cast iron engine block http://ozdat.com.au/forum/viewtopic.php?t=34828 |
Page 1 of 1 |
Author: | d [ Sat Dec 29, 2018 12:31 am ] |
Post subject: | Casting a new big bore L16 cast iron engine block |
Just theoretically speaking would anyone know how much to cast a new engine block eg. L16 to take 92mm bores, high content graphite iron, 4 bolt mains and bellhousing for Tremec T5 or aisin 6speed? Sand cast was my thinking using todays grey cast iron engine block techniques but probably 3d printing would be easier and cheaper for a one off or sand mold Could be made with closed deck and drilled to suit either SR or other head Crankshaft to suit SR for ease of aftermarket parts. Might even be used by drifters and drag cars with boost rather than expensive billet blocks. |
Author: | Lurch [ Mon Dec 31, 2018 6:29 pm ] |
Post subject: | Re: Casting a new big bore L16 cast iron engine block |
Is this finished yet? |
Author: | Dave [ Tue Jan 01, 2019 9:58 am ] |
Post subject: | Re: Casting a new big bore L16 cast iron engine block |
I'm on the other side of the world to my Datsun bits so can't have a look, but would you fit 92mm bore without the bores almost overlapping ? |
Author: | d [ Tue Jan 01, 2019 7:07 pm ] |
Post subject: | Re: Casting a new big bore L16 cast iron engine block |
The Ka24de can take 91.1mm bores for sigma 2.6 pistons so Im pretty sure any L series could accommodate 92mm bores, if there was enough material to start with! A new cast would be a surer way to make full use of FIA heads true potential and KA24de heads Max potential |
Author: | d [ Tue Jan 08, 2019 11:52 am ] |
Post subject: | Re: Casting a new big bore L16 cast iron engine block |
Looks like a metal 3d printer will be cheaper and easier than getting some 3rd world country to cast anything. Titanium and Iron 3d printers are filling the void soon enough! https://newatlas.com/hre-3d-printed-tit ... eel/57374/ https://www.designnews.com/materials/ma ... 9356458598 |
Page 1 of 1 | All times are UTC+11:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |